When we make the metal dome array by mold, the burrs will be found in the production process, then why do it’s happened, and what can we do to solve it?
Caused reasons and solutions as below:
1. The mold for outline is not level – adjust mold balance;
2. The outline mold is not sharp – to do repair again for mold;
3. The large gap between the mold – according to engineering specifications gap to adjust;
4. The material is too thinner – using the appropriate thickness of the material.
For unqualified products, we are not allow to delivery from our factory, we have a strict quality management system to ensure the quality of our metal dome arrays. If our products have the quality problems, we will take full responsibility.